2024 Case IH DC93

2024 Case IH Disc Mower Conditioners DC93 (Roll)

Fast cutting and high-quality conditioning for superior hay quality and windrow formation. An expanded variety of new models with additional cutting widths.

9’2” of cutting width available with rubber roll or flail conditioning.

Features may include:

DURABILITY

The fully encased modules provide superior hillside lubrication compared to competitive systems. This system contains any failure internally within a module as there is no free-flowing oil between each.

Each module is protected from damage by an external shear hub located under the disc and on top of the module. The hub is designed to take the damage from a severe impact. Repair is fast and convenient by simply removing a few bolts and replacing the hub. There is no need to open the module exposing the lubricants to chaff and debris.

A simplified drive system with fewer parts and larger gears, bearings and interconnecting shafts creates added durability in the DC3 disc mower conditioners.

All DC3 mower conditioner cutterbars are backed by a three-year warranty. This warranty covers all internal drive components.

VERSATILITY

For the ultimate in convenience, all DC3 mower conditioners are equipped with quick-change knives. Simply use the provided tool to change knives in seconds. Spend more time mowing and less time with maintenance.

Every field and every cutting has its own challenges. To fine tune your cut, several knife options are available to meet any condition. Options include various degrees of twist, serrations and a knife for rocky fields.

All DC3 mower conditioners include hydraulic cutterbar tilt. Make changes to your cutting height without tools by simply repositioning a pin in the cylinder. As the tilt is built into the lift circuit an additional hydraulic remotes is not needed. DC3 mower conditioners require only two remotes on the tractor to operate.

MAXIMIZED PROFIT

The low-profile cutterbar with wide discs cut closer and cleaner to encourage faster crop regrowth.

More counter-rotating discs provide efficient crop feeding into the conditioners.

The design of the cutterbar allows for reduced crop travel between cutterbar and conditioners, minimizing plugging. The driveshaft is on the left end only, for reduced clutter and cost.

The larger diameter discs allows for the elimination of co-rotating discs on the 13' models and allowing for only one set on the 16' models.

The cutterbar on the DC3 series center pivot mower conditioners features a combination of larger disc diameters and wider conditioning systems that allow a short and smooth transition of crop flow to the conditioning system for improved windrow consistency in tall crops.

The larger, heavier discs allow for greater shock protection and lower cutting heights at a reduced angle for consistent cut height without scalloping.

The innovative cutterbar design aids in the elimination of co-rotating discs from the 13’ model and one set from the 16’ model.